Alpine MC20 Operating Instructions - Page 8

Re-Pairing Procedure, Add-on Commander Pairing Procedure - power

Get Alpine MC20 PDF manuals and user guides
UPC - 793276420305
View all Alpine MC20 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

MC20 Display Unit Re-Pairing Procedure * To pair an MC20 display unit with a different MC20 system than the one it was purchased with Gust like adding an MC2 Commander) follow the instructions below: 1. Power on the MC20 system that you want to add the additional MC20 display unit to 2. Connect power and ground wires of new MC20 display unit 3. Wait at least 20 seconds, then enter the Program Menu (see Program Menu Example) 4. Go to the RESET MC2 option, then press ENT button 5. MC20 display unit will reset itself (including factory default settings) and display will show ADD MC2 like in step 3 of the previous section (MC2 Add-on Commander Pairing Procedure) 6. Follow the remaining steps of the previous section to complete this operation Dual Zone Volume and Mute Control Volume Control 1. Press and hold the VOLUME ZONE button to change zones SELECT ALL SELECT ZONE 1 SELECT . ZONE 2 Mute Control 1. Press and hold the MUTE button to select the mute zone(s) MUTE ALL MUTE ZONE 1 MUTE ZONE 2 2. After zone is selected, use the volume /'.. or.......", buttons to adjust the volume level 2. After mute zone is selected, press the MUTE button again momentarily to mute the selected zone(s) 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
MC20 Display Unit Re-Pairing Procedure
*
To
pair
an
MC20 display unit with a different MC20 system than the one it was
purchased with
Gust
like adding
an
MC2 Commander) follow the instructions
below:
1.
Power on the MC20 system that you want to add the additional MC20
display unit to
2.
Connect power and ground wires
of
new MC20 display unit
3.
Wait at least 20 seconds, then enter the Program Menu (see Program
Menu Example)
4.
Go to the
RESET
MC2 option, then press
ENT
button
5.
MC20 display unit will reset itself (including factory default settings) and
display will show ADD MC2 like
in
step 3
of
the previous section (MC2
Add-on Commander Pairing Procedure)
6.
Follow the remaining steps
of
the previous section to complete this
operation
Dual Zone Volume
and
Mute Control
Volume Control
1.
Press and hold the VOLUME ZONE
button
to
change zones
SELECT
ALL
Mute Control
1.
Press and hold the MUTE button
to
select the mute zone(s)
MUTE
ALL
SELECT
ZONE 1
SELECT
. ZONE 2
MUTE
ZONE 1
MUTE
ZONE 2
2.
After zone is selected, use the
volume
/'..
or
.......
",
buttons
to
adjust
the volume level
8
2.
After mute zone is selected, press the
MUTE button again momentarily
to
mute the selected zone(s)