Alpine MRV-M1200 Owner s Manual english - Page 9

2. Remove the insulation from the ends of the wire leads by about 7 - 10 mm (9/32" - 13/32"). 7 - 10 mm (9/32" - 13/32") Lead end side of the product Twist the tip of wire leads NOTES: • If length of the exposed wire is too short, a poor connection may occur causing operation failure or sound interruption. • On the other hand, if the length is too long, an electrical short-circuit may occur. 3. Tighten the hexagon hole screw with the hexagon wrench (included) to secure the lead. Before making this connection, use insulated shrink tubing to cover any exposed wire extending beyond the terminal. Hexagon hole screw Wire Wire Terminal Twist the tip of wire leads NOTES: • Use only the screws included. • For safety reasons, connect the battery leads last. • To prevent disconnection of the leads or dropping of the unit, do not use the cabling to carry the unit. 7-EN