Alpine PSS-23WRA Owners Manual - Page 6
Installation
View all Alpine PSS-23WRA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
UNLIMITED JL Jeep Wrangler 6/11 Installation 1 Connect the power cable to the Positive (+) battery terminal and route the cable down towards frame of the vehicle. Note: The Negative (-) terminal should remain disconnected until the installation is completed. 2 Route the power cable following the factory harness along the vehicle's frame. 3 Route the Positive (+) power cable through the grommet under the carpet and pull the power cable from under the vehicle. Note: seal the grommet with silicone (not included) to prevent water from entering the cabin. 4 Mount the subwoofer level remote on the center console next to the gear shifter and route the cable to the passenger side seat. Front of Vehicle 5 Connect the power cable to the main harness. 6 Attach the Negative (-) ground terminal to the factory ground stud below the center console.