Alpine V180A Operation Manual - Page 11
Troubleshooting guide, Specifications - car audio
View all Alpine V180A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Troubleshooting guide Specifications English If you encounter a problem, please review the items in the following checklist. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult your authorized ALPINE dealer. Symptom The POWER button does not function. The power is turned on but the unit does not operate. The picture is not clear. No picture on Monitor screen during playback or recording. Unable to record. No Remote Control operation. Remedy • Turn the ignition on. • Check connections and correct any problems. • Check the vehicle's battery voltage. • Moisture condensation. Allow unit to dry for 1 hour or more. • Adjust the tracking with TRACKING/SELECT buttons. • Check the connection between the Monitor and VCR, then connect them properly. • Have the video heads cleaned (with a cleaning tape sold separately) • The safety tab of the tape is removed. Cover the hole with adhesive tape. • Make sure the tape is not at its end. • Set "REC INHIBIT" to "NO" in the MENU screen. • Remove any obstacle between the Remote Control and the VCR. • Replace batteries with new ones. Insert them correctly. • Make sure you are pointing the Remote Control at the remote sensor on the unit. GENERAL DC Power Power consumption Dimensions Mass Operating temperature Operating humidity : 12 V DC car battery (Negative ground) : 9 Watts : 258 ! 89 ! 251 mm (w/h/d) : Approx. 3.3 kg : 0° to +40°C (32°F to 104°F) : Less than 80% RH VIDEO Format Video signal system Video heads Tape format : VHS standard : Standard NTSC 525 lines,60 fields : 4 heads : VHS 1/2-inch Cassette tape. AUDIO Audio track : 1 track (Normal-mono) 2 channels (Hi-Fi sound) CONNECTORS Video output : VIDEO OUT, 1.0 V (p-p), 75Ω (Phono type jack) Audio output : AUDIO OUT, 300 mV (rms), less than 47 kΩ (Phono type jack) Cautions Concerning Maintenance • Plastic is used extensively in the front of the cabinet. If it is wiped with benzene or paint thinner, etc., it could cause deterioration or pealing of the paint finish, etc., so avoid use of such cleaners. • Please wipe off dirt on the cabinet or operating panel with a soft cloth. When the product becomes dirty use a cloth dampened with a non-abrasive or non-harsh cleaning solution. Wring the cloth out completely, then wipe. Dry the finish by wiping with a dry cloth. • Do not allow volatile substances, such as insecticides, on the cabinet. Also, do not leave products made of rubber or vinyl, etc. in contact with this unit for long periods of time. Doing so could cause damage to the products finish. E-10 Design and specifications are subject to change without notice. VPE-V180A_English 10 4/25/00, 2:02 PM