Alpine i407-WRA-JK Installation Manual - Page 10

Jeep Wrangler i407-WRA-JK 20210811v1 ˜ 10/18 i407-WRA-JK Wiring Diagram To Vehicle Connectors To OBDII Connector Power/Speaker 16-pin Green Connector Antenna Adapter AMPLIFIED VEHICLES WARNING! Failure to follow this procedure will result in no audio from Navigation and Bluetooth sources. Microphone 10-pin Green Connector (Vehicle signals) 3-pin Black Connector (Power) 4-pin Black Connector (Data) Main Harness Not Not Used Used Red Not Reset Used Button 10-Pin Chime 18-Pin iDatalink MAESTRO Module 3-Pin 4-Pin 10-Pin 3-Pin 4-Pin Not Used Blue Not Used MANUAL TRANSMISSION VEHICLES White/Gray Manual Transmission Reverse Input For manual transmission vehicles ONLY. Connect the White/Gray wire to the White/Gray wire located on the passenger side kick panel. Blue/White Amp Turn-on Blue Power Antenna Yellow -12V+ Red - Acc 12V+ Black - Ground AUX Power 3-pin Black Connector Rear View Camera Rear View Camera 6-pin Black Connector If using HCE-TCAM1-WRA WARNING! see page 15 The use of this connection is intended for Alpine HCE-TCAM1-WRA rear view camera ONLY. 18-pin Black Connector Front Rear Front Rear Front Rear For factory ampli ed vehicles switch the speaker connectors, front to rear and rear to front. See page 12 for HDMI connection info USB Extension iLX-407 USB Rear Front Aux Input Cable (Sold Separate 3rd Party Cable) Audio Only No Video (White) (Red) (Yellow) Video (Yellow) Ground Audio R (Red) Audio L (White) Aux Video Input This is the only way to get RCA video into the head unit. HDMI IN VIDEO IN/OUT ANTENNA CAN I/F MIC SWC SXM/DAB CAMERA/PRE OUT POWER CAN/IF Power Harness Aux Input Rear Camera Input Front Camera Input Optional Rear Camera Optional Front Camera