American Standard 3208.016.222 Installation Instructions - Page 1

SAVE FOR FUTURE USE INSTALLATION INSTRUCTIONS For Two-Piece Toilets with Aquameter™ Fill Valve REPERTOIRE 2266/2483 HERITAGE 2176 ANTIQUITY 2264/2464 WILLIAMSBURG 2264.702 Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes ! CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE! NOTE: Pictures may not exactly define contour of china and components. RECOMMENDED TOOLS AND MATERIALS Putty Knife Regular Screwdriver Adjustable Wrench Hacksaw Wax Ring/Gasket Flexible Supply Tube Sealant Closet Bolts 1 REMOVE OLD TOILET Tape Measure Carpenters Level a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl. b. Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply! c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases. d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area. NOTE: Mounting surface must be clean and level before new toilet is installed! 2 ROUGHING-IN DIMENSIONS: NOTE: Distance from wall to closet flange centerline must be as listed below: FINISHED WALL 3 CLOSET FLANGE 12" (305mm) CLOSET BOLTS 12 (305mm) SUPPLY AS REQUIRED FINISHED FLOOR Product names listed herein are trademarks of American Standard Inc. © American Standard Inc. 2006 INSTALL CLOSET BOLTS Install closet bolts in flange channel, turn 90˚, and slide into place 6" (152 mm) apart and parallel to wall. Saniwares 730489-100 Rev. B