Antec P280 White Manual - Page 14

To install a 5.25 drive, you will need to remove the side panel and open, ur 5.25 drive through

Get Antec P280 White PDF manuals and user guides View all Antec P280 White manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

To install a 5.25" drive, you will need to remove the side panel and open the front door. For side panel removal, please see Section 2.1. 1. With the side panel off, carefully push the drive bay cover out of the drive bay. 2. Slide your 5.25" drive through the front of the chassis until it lines up flush with the front bezel. You will feel the drive lock into position. 3. If you need more clearance on the inside of the chassis for your drive, pull the drive bay tab on the inside of the chassis toward you and push the drive in further. To install a 5.25" drive, begin by opening the front door. Make sure to also remove the side panel as well (see Section 2.1 for more information) Slide your 5.25" drive through the front chassis until it lines up flush with the front bezel. 13 (See step 3 above if you need more clearance for your drive.)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
To install a 5.25” drive, you will need to remove the side panel and open
the front door. For
side panel removal, please see Section 2.1.
1.
With the side panel off, carefully push the drive bay cover out of the drive bay.
2.
Slide yo
ur 5.25” drive through the front of the chassis until it lines up flush with the
front bezel. You will feel the drive lock into position.
3.
If you need more clearance on the inside of the chassis for your drive, pull the
drive bay tab on the inside of the chassis toward you and push the drive in further.
13
To install a 5.25” drive, begin by opening the front door.
Make sure to also remove the side panel as well
(see Section 2.1 for more information)
Slide your 5
.25” drive through the front chassis until it lines up
flush with the front bezel.
(See step 3 above if you need more clearance
for your
drive.)