Ariens Max Zoom 60 Owners Manual - Page 16
FILLING FUEL TANK, GASOLINE, PRE-START, To add fuel to the fuel tank, Fuel Stabilizer - oil change
View all Ariens Max Zoom 60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
NOTE: The hour meter is preprogrammed for the initial oil change at 25 hours and for 100 hours thereafter. The hour meter is programmed for the initial hydraulic oil and filter change at 75 hours and for 400 hours thereafter. Display Toggle Button FILLING FUEL TANK WARNING: AVOID INJURY. Read and understand entire Safety section before proceeding. Add fuel to Fuel Tank as needed. See your Engine Manual for correct type and grade of fuel. To add fuel to the fuel tank: 1. Clean fuel caps and surrounding area to prevent dust, dirt, and debris from entering fuel tanks. 2. Remove fuel caps. IMPORTANT: Refer to Engine Manual for correct type and grade of fuel. 3. Fill fuel tank to the bottom of filler neck. See Specifications on page 33 for fuel tank capacity. IMPORTANT: DO NOT OVERFILL! This equipment and/or its engine may include evaporative emissions control system components, required to meet EPA and/or CARB regulations, that will only function properly when the fuel tank has been filled to the recommended level. Overfilling may cause permanent damage to evaporative emissions control system components. Filling to the recommended level ensures a vapor gap required to allow for fuel expansion. Pay close attention while filling the fuel tank to ensure that the recommended fuel level inside the tank is not exceeded. Use a portable gasoline container with an appropriately sized dispensing spout when filling the tank. Do not use a funnel or other device that obstructs the view of the tank filling process. 4. Replace fuel cap and tighten. 5. ALWAYS clean up spilled fuel. GASOLINE IMPORTANT: ALWAYS use gasoline that meets the following guidelines: • Clean, fresh gasoline. • A minimum of 87 octane/87 AKI (91 RON). High altitude use may require a different octane. Consult your engine manual. • Gasoline with up to 10% ethanol (gasohol) or up to 10% MTBE (methyl tertiary butyl ether) is acceptable. • Use of any gasoline other than those approved above will void the engine warranty. If the pumps are not marked for the content of alcohol or ethers, check ethanol and MTBE levels with the fuel supplier. • Do not modify the fuel system to use different fuels. • Never mix oil and gasoline. NOTE: All gasoline is not the same. If the engine experiences starting or performance problems after using a new gasoline, switch to a different fuel provider or fuel brand. IMPORTANT: Excessively oxygenated or reformulated fuels (fuels blended with alcohols or ethers) can damage the fuel system or cause performance problems. If any undesirable operating problems occur, use a gasoline with a lower percentage of alcohol or ether. Fuel Stabilizer Gasoline left in the fuel system for extended periods without a stabilizer will deteriorate, resulting in gum deposits in the system. These deposits can damage the carburetor and the fuel hoses, filter and tank. Prevent deposits from forming in the fuel system during storage by adding a quality fuel stabilizer to the fuel. Follow the recommended mix ratio found on the fuel stabilizer container. PRE-START CAUTION: Make sure all hardware is tight, all safety devices are in place and all adjustments are made correctly. 1. Check Safety Interlock System If this system does not function as described do not operate until repairs are made. 2. Check Air Cleaner Check air filter for dirt. Clean as required. Follow Engine Manual Maintenance Schedule. GB - 16