Ariens Pro-24 HWM SP Owners Manual - Page 7

DO NOT mow at too fast a rate. DO NOT change engine governor setting or overspeed the engine. Do not operate mower on gravel or loose material such as sand. Stop mower when crossing drives, walks, or roads to prevent damage or injury from thrown objects. DO NOT pull mower backwards unless absolutely necessary. Look down and back, especially for small children, before and while moving backwards. On self-propelled models, releasing wheel drive control must stop mower's forward movement. If this feature fails to operate, disconnect spark plug wire and repair before using unit. On self-propelled models, wheel drive must be disengaged when starting engine. DO NOT operate on steep slopes. NEVER leave unit unattended on a slope. Chock wheels if parking on a slope. Mow across the face of slopes, never up and down. Be especially cautious when changing direction on slopes. Maximum slope angle of operation is 20º. This product is equipped with an internal combustion engine. DO NOT use on or near any unimproved, forest or brush covered land unless the exhaust system is equipped with a spark arrestor meeting applicable local, state or federal laws. A spark arrestor, if used, must be maintained in effective working order by the operator. See your Ariens Dealer or engine manufacturer's service center. Accidental engine start up can cause death or serious injury. Except where specifically recommended, ALWAYS stop engine, remove key (electric start models), wait for moving parts to stop, allow parts to cool and disconnect spark plug wire before inspecting, servicing, adjusting or repairing unit. Avoid Electric Shock. DO NOT disconnect wire from spark plug while engine is running. Keep equipment in good condition. Maintain or replace safety and instruction labels, as necessary. Follow engine manufacturer's safety instruction when servicing engine. Check all hardware at regular intervals, especially blade attachment bolts. Keep all hardware properly tightened. An extension spring, when extended, stores energy and can be dangerous. Always use tools specifically designed for installing or removing an extension spring. Always compress or extend springs slowly. Before tipping unit, remove fuel and battery (if equipped). Use extra care when loading or unloading unit onto trailer or truck. CAUTION: DO NOT drop machine when loading or unloading or damage to rear axle may occur. Ensure all wheel blocks, jack stands and tie downs will support unit during maintenance. Replace worn-out mufflers immediately. Continued use could result in fire or explosion. Sharp edges can cut or amputate fingers or a hand. Wrap blade or wear sturdy gloves to service. Only replace blades. NEVER straighten or weld blades. Use only replacement parts designed for your unit. See your Ariens Dealer. Allow engine to cool before storing in any enclosure. ALWAYS clean unit before extended storage. See engine manual for proper storage. DO NOT store unit inside a building with fuel in the fuel tank where any ignition sources are present. Use only accessories which have been approved by Ariens and are properly installed. Use only accessories or attachments that are designed for your unit and that can be used safely on your terrain. Check attachments frequently and replace worn or damaged components with manufacturer's recommended parts. GB - 7