Asko D5436XLS Installation instructions EN - Page 6

CORNER INSTALLATION If the dishwasher is installed in a corner, there must be a minimum clearance of 2˝ (50 mm) from the side wall so the door can open. 2˝ clearance EASYINSTALL CONNECTIONS PEX tubing with 3/8˝ compression fitting PEX tubing has a 95-year spec life. Fits American dishwasher water supply valves. Be sure to install the O-Ring which is attached to the PEX tubing in a plastic bag. Drain hose boot Ready to be cut to desired drain connection. Only one clamp required. Electrical cord 120 volts, 15 amp cord is supplied with the dishwasher. WARNING! Do not use an extension cord for this appliance. WATER SUPPLY WARNING! Plumbing connections must comply with applicable sanitary, safety and plumbing codes in your area. The machine can be connected to either a hot (max. 160 °F, 70 °C) or cold water supply. We recommend a cold water supply. The water pressure should be 4.2-140 psi. Connect to cold water... If you use oil or electricity to heat your home. Connect to hot water (max 160 °F, 70 °C)... If you use district heating, solar power, or geothermal power to heat your home. Choosing a hot water connection cuts program times and reduces the dishwasher's electricity consumption. The dishwasher comes with a 6-foot PEX water supply line that has a 3/8˝ NPT female connection. After determining where the water supply line will enter under the sink, drill a 1-1/2˝ (38 mm) access hole and run the line to the approximate inlet valve location shown in the figure below. The water line inlet valve is on the right rear of the machine. For service convenience, a shut-off valve (not supplied) should be installed in the supply line in an easily accessible location, such as, beneath the sink. It is important that the water supply line and the shut off valve have a sufficient flow volume. At least 3 gallons (12 liters) per minute must be able to pass through the line. The water pressure should be 4.2-140 psi. WARNING! In order to prevent heat damage to the inlet valve, all solder connections must be made before the water line is connected to the dishwasher. 1. Water supply 2. Water supply valve to dishwasher (not supplied) NOTE: Be sure to run the PEX tubing through the hole to the sink compartment before moving the dishwasher into position. 6 CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM