Asko T702 User manual Use & Care Guide Asko T702 EN - Page 21

Installation instructions How to assemble the stacking kit: 1. Undo the anti-tip device. 5. Fit the plastic cups so that the "tags" marked with arrows are against the front edge or side edge of the cover and press them firmly onto the cover. Then break off the remaining tabs. 2. Remove the two screws indicated on the back of the washing machine. 6. Push out the knock-out hole on the back of the dryer (you don't have to completely remove the knockout, just fold it up far enough for the stacking bracket to fit inside the slot) using a hammer and screwdriver. 3. Secure the anti-tip device using the screws as shown in the picture. 7. Push the tumble dryer in under the metal brackets. At the same time, keep the front edge raised by 0,4" (10mm) to 0,8" (20mm). 4. Attach the plastic cups for mounting the tumble dryer's front feet to the washing machine's top cover. This is essential, as only when the tumble dryer's feet are resting in the plastic cups can you be sure that the dryer is correctly positioned on the washing machine. Break off tab A on the cup fitted on the right side and tab B on the cup fitted on the left side. Then remove the paper from the self-adhesive surface under the plastic cups. 8. Lower the tumble dryer's front feet into the plastic cups and adjust the dryer to ensure that it is balanced. AA BB Customer Care Center 21 1-800-898-1879 www.askousa.com