Asko T731 User manual Use & Care Guide EN - Page 11

OPERATING INSTRUCTIONS THE CONTROL PANEL Power Button Power Indicator Light Programs Iron dry Timed dry Air fluff Extra dry LED Window Start Button Dry Normal dry Stop Button Program Knob Option Buttons POWER BUTTON The Power button turns the power to the machine on and off. When the power is on, the power indicator light glows red. The power must be on before you can start the machine. STOP BUTTON You can interrupt a program by pressing and holding the Stop button until the dryer stops. When you press Start, the program will start from the beginning. If you don't want the program to restart from the beginning, you can stop the unit by opening the door. If you stop the dryer this way, when you press Start the unit will continue from the point it was interrupted. PROGRAM KNOB Turn this knob to select a program. The programs are described on the following page. 12:00 Position - This is where the line on the knob aligns with the line above the knob. When the knob is in this position, "00" displays on the LED to indicate no program has been chosen. OPTION BUTTONS The option buttons allow you to select program time, normal or low temperature, anti-crease, delayed start, buzzer and quick cooling. Each of these options is defined in more detail in the following paragraphs. LED WINDOW The LED window displays the program number for the Sensidry programs, as illustrated below: TIME If you set the program knob to Timed Dry or Air Fluff, you must select the length of drying time by pressing this button until the number of minutes you wish to dry the load displays on the LED. The time advances in 5-minute increments and you can select between 5 and 90 minutes. If you pass the time you wanted to select, continue to press the button until the correct time displays. P1 The corresponding program numbers are: Extra dry = P1 Dry = P2 Normal Dry = P3 Iron Dry = P4 When you select Timed Dry, the LED displays the number of minutes selected, plus the cool-down time, as illustrated below: ATI-CREASE The Anti-crease option prevents garments from wrinkling if you're unable to remove them right away. You can select one, two, or three hours by pressing the Anti-crease button until the number of hours you prefer displays, as illustraed below: 25 When you select Air Fluff, the LED displays the number of minutes selected, as illustrated above. With both programs 5 and 6, as the program advances, the LED displays the remaining time. "End" on the LED indicates the program is complete. "C" indicates the program is in the cool-down cycle. 1h NOTE: "0" on the LED indicates the option is not active. When you set a time, the drum will continue to rotate after the program is complete for three seconds every minute until the door is opened or the selected time (1-3 hours) has passed. If the buzzer is on, it will sound each time the anti-crease program activates. START BUTTON After you have selected a program and the desired options, press this button to start the dryer. The red indicator light next to the Start button will come on. The indicator light will go off when the program ends or has been cancelled. If you open the door during a program, the dryer will stop tumbling automatically and the Start button indicator light will blink. To continue the program, close the door and press Start again. To cancel the program, press and hold the Stop button until the Stop indicator light goes off (approximately 3 seconds). Page 11 ENGLISH