Asko T731 User manual Use & Care Guide EN - Page 8
Asko T731 Manual
View all Asko T731 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
REVERSING THE DOOR HINGES The door hinges on ASKO dryers are reversible. The dryers are shipped left-hinged. To reverse them, follow the steps below: WARNING! Switch off the main power supply before you start this procedure. 12. Using a flathead screwdriver, carefully remove the plastic plugs in the upper and lower edge of the door and place them in the empty holes on the opposite side. 13. Remove the screw in the top right corner of the bottom panel, as indicated in the illustration. 14. Now you are ready to mount the door on the right side. Holding the door at an angle (as illustrated), fit the hinge pin into the top hole. 1. Remove the two 20 torx screws on the bottom of the bottom panel then grasp the bottom of the panel and pull it forward and down. 2. Remove the bottom hinge by removing the three screws holding the hinge in place. 3. Supporting the door from the bottom, pull it out and to the left as you turn the hinge counter clockwise. 15. Replace the bottom hinge with the screws in the order illustrated at right (a, b, c). Hinge pin 4. 5. Remove the hinge pin at the top. Turn the hinge upside put the hinge pin into the top hole. Transfer the top hinge pin to the right side of the dryer casing. down and 16. Replace the screw you removed in step 13 (d). 17. Replace the lower panel. 18. Turn back on the main power. 6. 7. Loosen the two screws on both outer edges of the door so you can remove the magnetic door catch and the cover plate. Remove the magnetic catch by pushing it up then lifting it out from the bottom. 2 2 8. 2 1 9. Remove the cover plate on the opposite side of the door by pushing it down then lifting it out from the top. 10. Reverse steps 8 and 9 to place the door catch and cover plate into their new positions. 11. Tighten the screws on the sides of the doors to hold the magnetic catch and cover plate in place. Page 8