Asko T754C User manual 8095056 Asko T754C EN - Page 22

Installation instructions NOTE! Exhaust holes not required for condenser dryers. ASKO dryers can be installed beneath a cabinet or worktop with a minimum height of 34" (864 mm). There must be a gap of about 1/2" (12 mm) all around the machine, including between the rear edge of the machine top panel and the back wall. The opening width must be at least 24-1/2" (622 mm). The condensing models work best when they have good air circulation. Install the dryer so the condensed water will continuously flow into a drain or sink, you will need a drain outlet behind the unit. The maximum drain height is 40" (1016 mm). NOTE! The height adjustment for the dryer is 33-1/2" to 34-1/2" (850 mm to 876 mm). Do not raise it higher than 34-1/2" (876 mm). Hole measurements are from center of hole. Install in a closet ASKO's front panel controls make it possible to install the washers and dryers in a closet. Make sure there is a ½" (12mm) minimum clearance between units and cabinet or wall. To ensure proper ventilation, we recommend louvered doors, particularly for condenser dryers. Otherwise there must be ventilation openings in the door. See illustration for minimum ventilation openings: Condensed water Install the dryer so the condensed water will continuously flow into a drain or sink. To do this, follow the instructions below: 1. Connect the rubber hose supplied with the dryer to the blue nipple. 2. Run the hose to a drain or sink, as illustrated. NOTE! The drain hose must not be more than 40" above the floor. 22 Customer Care Center 1-800-898-1879 www.askousa.com