Asko W4114CW Use and Care Guide English - Page 43
Failure Display
View all Asko W4114CW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
FAILURE DISPLAY In case of a failure while a program is in progress, the relevant Error X is indicated on the display unit. Error 3 Press the INFO button to display the Info Exit error description. Switch off the appliance and turn it back on. 5 Errors indicated on the display unit may include the following: Error Error indication on the display What to do? unit E0 INCORRECT SETTINGS Restart the program. If the error reoccurs, call a service technician. E1 THERMISTOR ERROR Temperature sensor error. • Inlet water too cold. Repeat the washing program. • If the appliance reports this error again, call a service technician. E2 DOOR LOCK ERROR Turn the appliance OFF and then switch it ON again. Start the program again. If the error reoccurs, call service technician. E3 WATER FILLING ERROR Check the following: • is the water inlet valve open, • is the filter on the water inlet hose clean, • is the water supply hose deformed (clipped, clogged etc.), • is the pressure in the water mains between 0.1 and 1 MPa (1-10 bar). Then, press the Exit button to resume the program. If the error reoccurs, call a service technician. E6 HEATING ERROR Water heating error. Restart the program. If the error reoccurs, call a service technician. E7 DRAINING ERROR Water draining error. Check the following: • is the pump filter clean, • is the drain hose clogged, • is the drain clogged, • is the drain hose fitted at the right height (see chapter on drain hose installation in the instruction manual). Then, press the Exit button again. If the error reoccurs, call a service technician. E10 WATER LEVEL SENSOR ERROR Turn the appliance OFF and then switch it again ON. Start the program again. If the error reoccurs, call service technician. E11 OVERFLOW Water overflowing. If there is water in the drum that exceeds a certain level, and an error is reported on the display unit, the washing program will be interrupted and water will be pumped out of the washing machine. Restart the program. If the error reoccurs, call a service technician. If there is water in the drum that exceeds a certain level, and an error is reported on the display unit, while the washing machine continues to add water, close the water tap and call a service technician. E12 MOTOR ERROR / MOTOR CONTROL ERROR Restart the program. If the error reoccurs, call a service technician. Customer Care Center, 1-800-898-1879, www.askona.com 43