Asus M2A-MVP M2A-MVP English Edition User's Manual - Page 42
Serial ATA hard disk drive connection - windows 7
UPC - 610839148028
View all Asus M2A-MVP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
• Plug your Serial ATA boot disk on the master port (SATA1/2 to support S3 function). • Install the Windows® 2000 Service Pack 4 or the Windows® XP Service Pack1 or later when using Serial ATA. Serial ATA hard disk drive connection Connector SATA1/SATA2 SATA3/SATA4 Color Red Black Setting Master Slave Use Boot disk Data disk 4. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. +5VSB_MB Chassis Signal GND M2A-MVP CHASSIS (Default) M2A-MVP Chassis intrusion connector 1-30 Chapter 1: Product introduction