Asus M3A78 EM User Guide - Page 48
Chassis intrusion connector 4-1 pin CHASSIS, IEEE 1394a port connector 10-1 pin IE1394_1
UPC - 610839163540
View all Asus M3A78 EM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
11. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "GND" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. +5VSB_MB Chassis Signal GND R M3A78-EM CHASSIS M3A78-EM Intrusion Connector (Default) 12. IEEE 1394a port connector (10-1 pin IE1394_1) This connector is for a IEEE 1394a port. Connect the IEEE 1394a module cable to this connector, then install the module to a slot opening at the back of the system chassis. TPA1GND TPB1+12V GND TPA1+ GND TPB1+ +12V R M3A78-EM IE1394_1 1 M3A78-EM IEEE 1394a Connector 1-36 Chapter 1: Product introduction