Asus M4A89TD PRO/USB3 User Manual - Page 45
Internal connectors
View all Asus M4A89TD PRO/USB3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
2.7.3 Internal connectors 1. IDE connector (40-1 pin PRI_EIDE) The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Chapter 2 Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices. If any device jumper is set as "Cable-Select", ensure that all other device jumpers have the same setting. ASUS M4A89TD PRO Series 2-27