Asus M4N75TD User Guide - Page 37
NVIDIA nForce, 750a SLI, Serial ATA connectors 7-pin SATA1-6 - nvidia nforce 750a
View all Asus M4N75TD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
3. NVIDIA nForce® 750a SLI® Serial ATA connectors (7-pin SATA1-6) These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk and optical disk drives. The Serial ATA 3Gb/s is backward compatible with Serial ATA 1.5Gb/s specification. The data transfer rate of the Serial ATA 3Gb/s is faster than the standard parallel ATA with 133 MB/s (Ultra DMA133). If you install SATA hard disk drives to the SATA connectors, you can create a RAID 0, RAID 1, RAID 0+1, RAID 5, or JBOD configuration through the onboard NVIDIA nForce® 750a SLI® controller. • SATA 5-6 connectors support AHCI mode and RAID mode only. Make sure to install the AHCI driver or RAID driver in the bundled support DVD before connecting devices to SATA 5-6 connectors. Otherwise, the devices will not work. • Due to chipset limitation, when set any of SATA ports to RAID mode, all SATA ports run at RAID mode together. • You must install Windows XP® Service Pack 2 or later version before using Serial ATA hard disk drives. • SATA1-4 connectors are set to [IDE Mode] by default. If you intend to create a Serial ATA RAID set using these connectors, set the SATA Mode select item in the BIOS to [RAID Mode]. See page 2-10 for details. • Before creating a RAID set, refer to the manual bundled in the motherboard support DVD. Chapter 1: Product introduction 1-25