Asus MEL-C MEL-C User Manual - Page 27

Rotation +12V GND III. H/W SETUP Connectors III. HARDWARE SETUP 11. Chassis,CPU,&PowerSupplyFanConnectors(3-pinCHA_,CPU_,PWR_FAN) These connectors support cooling fans of 500mAMP (6 Watts) or less. Orientate the fans so that the heat sink fins allow airflow to go across the onboard heat sink(s) instead of the expansion slots. Depending on the fan manufacturer, the wiring and plug may be different. The red wire should be positive, while the black should be ground. Connect the fan's plug to the board taking into consideration the polarity of the this connector. NOTE: The "Rotation" signal is to be used only by a specially designed fan with rotation signal. WARNING! The CPU and/or motherboard will overheat if there is no airflow across the CPU and onboard heatsinks. Damage may occur to the motherboard and/or the CPU fan if these pins are incorrectly used. These are not jumpers, do not place jumper caps over these pins. Power Supply Fan CPU Fan Power GND +12V Rotation Chassis Fan Power GND +12V Rotation MEL-C 12-Volt Cooling Fan Power 12. Wake-On-LAN Connector (3-pin WOL_CON) These connector connects to LAN cards with a Wake-On-LAN output, such as the ASUS PCI-L101 (see section on ASUS LAN Card). The connector powers up the system when a wakeup packet or signal is received through the LAN card. IMPORTANT: This feature requires that the WAKE On LAN Power Up Control is set to Enabled (see Power Management Setup under BIOS SETUP) and that your system has an ATX power supply with at least 720mA +5V standby power. +5 Volt Standby PME Ground MEL-C Wake-On-LAN Connector IMPORTANT: Requires an ATX power supply with at least 720mA +5-volt standby power ASUS MEL-C User's Manual 27