Asus P5BV-E SAS User Guide - Page 44
ICH7R primary IDE connectors 40-1 pin PRI_IDE1 and PRI_IDE3
View all Asus P5BV-E SAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
2. ICH7R primary IDE connectors (40-1 pin PRI_IDE1 and PRI_IDE3) These connectors are for Ultra DMA 100 / 66 signal cables. The Ultra DMA 100/66 signal cable has three connectors: a blue connector for the primary IDE connector on the motherboard, a black connector for an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive), and a gray connector for an Ultra DMA 100/66 IDE master device (hard disk drive). If you install two hard disk drives, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings. PRI_IDE1 ® P5BV-C/4L PRI_IDE3 PIN 1 NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. PIN 1 NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. P5BV-C/4L IDE Connectors • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100 / 66 IDE devices. 2-24 Chapter 2: Hardware information