Asus P5BV-E SAS User Guide - Page 50
Chassis intrusion connector 4-1 pin CHASSIS, TPM connector 20- pin TPM
View all Asus P5BV-E SAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
11. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. ® P5BV-C/4L CHASSIS +5VSB_MB Chassis Signal GND (Default) P5BV-C/4L Chassis Intrusion Connector 12. TPM connector (20- pin TPM) This connector is used to connect a Trusted Platform Module (TPM) Card. You need to install ASUS TPM card to use this feature function. ® P5BV-C/4L TPM GND NC AD2 AD1 GND NC SERIRQ# CLKRUN# NC PCICLK FRAME# PCIRST# AD3 3.3V AD0 NC 3.3VSB GND PWRDW# P5BV-C/4L TPM Connector The TPM module is purchased separately. 2-30 Chapter 2: Hardware information