Asus P5N32-E SLI Plus P5N32-E SLI Plus User''s Manual for English Edtion - Page 53
Serial ATA connectors 7-pin SATA1-6 - raid
View all Asus P5N32-E SLI Plus manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
PRI_IDE NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. ® P5N32-E SLI Plus PIN 1 P5N32-E SLI Plus IDE connector 3. Serial ATA connectors (7-pin SATA1-6) These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives. If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 0+1, RAID 5, or JBOD configuration�w��it�h��th�e��o�n�b��o�a�r�d�N��V�I�D��IA�® MediaShield™ RAID controller. The RAID function of these connectors is set to [Disabled] by default. If you intend to create a Serial ATA RAID set using these connectors, enable the RAID Enabled item under the Serial ATA Configuration sub-menu in the BIOS. See section "4.5.3 Onboard Device Configuration" for details. SATA2 SATA4 SATA6 GND RSATA_RXN2 RSATA_RXP2 GND RSATA_TXN2 RSATA_TXP2 GND GND RSATA_RXN4 RSATA_RXP4 GND RSATA_TXN4 RSATA_TXP4 GND GND RSATA_RXN6 RSATA_RXP6 GND RSATA_TXN6 RSATA_TXP6 GND ® P5N32-E SLI Plus SATA1 SATA3 SATA5 GND RSATA_RXN1 RSATA_RXP1 GND RSATA_TXN1 RSATA_TXP1 GND GND RSATA_RXN3 RSATA_RXP3 GND RSATA_TXN3 RSATA_TXP3 GND GND RSATA_RXN5 RSATA_RXP5 GND RSATA_TXN5 RSATA_TXP5 GND P5N32-E SLI Plus SATA connectors These connectors support Native Command Queuing (NCQ), Power Management (PM) Implementation Algorithm, Hot Swap and smart setup. ASUS P5N32-E SLI Plus 2-27