Asus P8Q67-M DO USB3 TPM User Manual - Page 23
P8Q67-M DO/USB3/TPM Chassis intrusion connector - m do tpms sensors
View all Asus P8Q67-M DO USB3 TPM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
3. CPU and chassis fan connectors (4-pin CPU_FAN, 3-pin CHA_FAN) Connect the fan cables to the fan connectors on the motherboard, ensuring that the black wire of each cable matches the ground pin of the connector. CPU_FAN CPU FAN PWM CPU FAN IN CPU FAN PWR GND P8Q67-M DO/USB3/TPM CHA_FAN GND +12V Rotation P8Q67-M DO/USB3/TPM Fan connectors Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside the system may damage the motherboard components. These are not jumpers! Do not place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan of maximum 2A (24 W) fan power. 4. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. CHASSIS +5VSB_MB Chassis Signal GND P8Q67-M DO/USB3/TPM P8Q67-M DO/USB3/TPM Chassis intrusion connector Chapter 1: Product introduction 1-13