Asus PRIME H310I-PLUS R2.0 PRIME H310I-PLUS R20 Users Manual English - Page 11

USB 3.1 Gen 1 (up to 5Gbps) connector (20-1pin U31G1_12) Connect a USB 3.1 Gen 1 module to this connector for additional USB 3.1 Gen 1 front or rear panel ports. This connector complies with USB 3.1 Gen 1 specifications and provides faster data transfer speeds of up to 5 Gbps, faster charging time for USB-chargeable devices, optimized power efficiency, and backward compatibility with USB 2.0. Intel® H310 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4) These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 Gb/s signal cables. M.2 socket 3 This socket allows you to install an M.2 (NGFF) SSD module. M.2(SOCKET3) • This M.2 socket supports M Key and 2260/2280 storage devices. • When a device in SATA mode is installed on the M.2 socket, SATA_2 port can not be used. PCI Express 3.0/2.0 x16 slot This motherboard has a PCI Express 3.0/2.0 x16 slot that supports PCI Express 3.0/2.0 x16 graphic cards complying with the PCI Express specifications. +5V SPDIFOUT GND Digital audio connector (4-1 pin SPDIF_OUT) Connect the S/PDIF Out module cable to this connector, then install the module to a slot opening at the back of the system chassis. Clear RTC RAM (2-pin CLRTC) This header allows you to clear the CMOS RTC RAM data of the system setup information such as date, time, and system passwords. PIN 1 SPDIF_OUT CLRTC +3V_BAT GND To erase the RTC RAM: PIN 1 1. Turn OFF the computer and unplug the power cord. 2. Use a metal object such as a screwdriver to short the two pins. 3. Plug the power cord and turn ON the computer. 4. Hold down the key during the boot process and enter BIOS setup to re-enter data. If the steps above do not help, remove the onboard battery and short the two pins again to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery. M.2 Wi-Fi Slot (E-key, type 2230) This connector allows you to connect a M.2 Wi-Fi module (E-key, type 2230) ASUS PRIME H310I-PLUS R2.0 1-3