Asus Pro H610M-C D4-CSM Pro H610M-C D4 Users Manual English - Page 11
USB 3.2 Gen 1 header, USB 2.0 headers, Chassis intrusion header, Clear CMOS header
View all Asus Pro H610M-C D4-CSM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
8. USB 3.2 Gen 1 header The USB 3.2 Gen 1 header allows you to connect a USB 3.2 Gen 1 module for additional USB 3.2 Gen 1 ports. The USB 3.2 Gen 1 header provides data transfer speeds of up to 5 Gb/s. The USB 3.2 Gen 1 module is purchased separately. USB3+5V IntA_P4_SSRXIntA_P4_SSRX+ GND IntA_P4_SSTXIntA_P4_SSTX+ GND IntA_P4_DIntA_P4_D+ PIN 1 USB3+5V IntA_P3_SSRXIntA_P3_SSRX+ GND IntA_P3_SSTXIntA_P3_SSTX+ GND IntA_P3_DIntA_P3_D+ GND USB+5V USB_7USB_7+ GND NC 9. USB 2.0 headers The USB 2.0 headers allow you to connect a USB module for additional USB 2.0 ports. The USB 2.0 headers provide data transfer speeds of up to 480 Mb/s. PIN 1 DO NOT connect a 1394 cable to the USB connectors. Doing so will damage the motherboard! USB+5V USB_8USB_8+ GND The USB 2.0 module is purchased separately. +5VSB_MB Chassis Signal GND 10. Chassis intrusion header This header is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this header. The chassis intrusion sensor or switch sends a high-level signal to this header when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. CHASSIS PIN 1 11. Clear CMOS header This header allows you to clear the CMOS RTC RAM data of the system setup information such as date, time, and system passwords. To erase the RTC RAM: CLRTC PIN 1 +3V_BAT GND 1. Turn OFF the computer and unplug the power cord. 2. Use a metal object such as a screwdriver to short the two pins. 3. Plug the power cord and turn ON the computer. 4. Hold down the key during the boot process and enter BIOS Setup to reenter data. If the steps above do not help, remove the onboard battery and short the two pins again to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery. RXD DTR DSR CTS 12. COM Port header This header is for a serial (COM) port. Connect the serial port module cable to this header, then install the module to a slot opening at the back of the system chassis. COM PIN 1 DCD TXD GND RTS RI Pro H610M-C D4 1-3