Asus RP-AC51 QSG Quick Start Guide - Page 2

3 METHOD WEB SUPPORT 01 Connect 02 Extend NOTE: The screenshot below is from a desktop PC. 1 On a web browser, enter http://repeater.asus.com. 2 Set a unique repeater login name and password. 3 Select the existing network you want to extend. 03 Configure 1 Tick Same with Parent AP SSID/Password to copy the router/AP's SSID and password for your extended network. You could also set a unique SSID and password for your extended network by typing in the text box. When done, click Apply. 
 ASUS_RPAC51 ASUS_RPAC51_5G Disconnect your Ethernet (wired) connection from your computer. Click the Wi-Fi icon on the taskbar and connect to RP-AC51's network: ASUS_RPAC51 or ASUS_RPAC51_5G. RELOCATION FIND THE BEST PLACE After a successful setup Place your RP-AC51 between your router/AP and wireless device to get the best performance. 45 ° 45 ° NOTE: Orient the two antennas at 45o angle for the best performance. MOVE CLOSER Need to move RP-AC51 closer to the router/AP. MOVE AWAY SLIGHTLY Need to move RP-AC51 slightly away from the router/AP. NOTE: To minimize maintenance, keep your RP-AC51 away from devices such as cordless phones, Bluetooth devices, and microwave ovens. IMPORTANT! We recommend that you place your RP-AC51 in open or spacious location. AP MODE AP MODE SETUP 01 Connect 02 Log in NOTE: The screenshot below is from a desktop PC. 1 Enter your login account and password. 2 From your RP-AC51's web interface, click Administration, and select Access Point mode. 03 Setup 1 Set up the network name (SSID) and click Apply. 2 After your RP-AC51 has rebooted, connect your RP- AC51 and router/AP using an Ethernet cable. ASUS_RPAC51 ASUS_RPAC51_5G NOTE: You can also change to different modes from this page. Disconnect your Ethernet (wired) connection from your computer. Click the Wi-Fi icon on the taskbar and connect to RP-AC51's network: ASUS_RPAC51 or ASUS_RPAC51_5G. Ethernet connection FAQ FREQUENTLY ASKED QUESTIONS Q1 What should I do if my router does not support WPS? A: You can use Method One or Method Three to set up your RP-AC51. Q2 Why is it that the LED indicator for the current network does not light up after the Wi-Fi setup is complete? A: You may have entered the wrong password for the router/AP. Please restart your RPAC51, enter the correct password, and try to set up your RP-AC51 again. Q3 Why is it that I cannot see the login page after entering http://repeater.asus.com in the browser? A: Ensure that your computer is connected to your RP-AC51 network only, and set your computer to Obtain an IP address automatically. If you still cannot find the login page, please download the ASUS Device Discovery utility. Q4 How do I reset RP-AC51? A: Press the RESET button on the side of RP-AC51 for about two (2) seconds. Wait for about five (5) seconds until the existing network LED blinks slowly. E12398_RP-AC51_QSG_Special_A3.indd 2 2017-04-05 16:37:59