Asus RS100-E5 User Guide - Page 105
LSI Software RAID Configuration
UPC - 610839665518
View all Asus RS100-E5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
6.3 LSI Software RAID Configuration Utility The LSI Software RAID Configuration Utility allows you to create RAID 0 or RAID 1 set(s) from SATA hard disk drives connected to the SATA connectors supported by the motherboard Southbridge chip. To enter the LSI Software RAID Configuration Utility: 1. Turn on the system after installing all the SATA hard disk drives. 2. During POST, the LSI Software RAID Configuration Utility automatically detects the installed SATA hard disk drives and displays any existing RAID set(s). Press + or to enter the utility. LSI MegaRAID Software RAID BIOS Version A.05.090611342R LSI SATA RAID Found at PCI Bus No:00 Dev No:1F Device present at port 0 Hitachi HDS721616P 156554MB Device present at port 3 Hitachi HDS721616P 156554MB Press Ctrl-M or Enter to run LSI Software RAID Setup Utility. - • The LSI Software RAID Configuration Utitlity auto configures to RAID 1 when the SATA to RAID Mode is enabled. • The RAID setup screens shown in this section are for reference only and may not exactly match the items on your screen due to the controller version difference. 3. The utility main window appears. Use the arrow keys to select an option from the Management Menu, then press . Refer to the Management Menu descriptions on the next page. At the bottom of the screen is the legend box. The keys on the legend box allow you to navigate through the setup menu options or execute commands. The keys on the legend box vary according to the menu level. LSI Software RAID Configuration Utility Ver A.53 Sep 06, 2007 Management Menu Configure Initialize Objects Rebuild Check Consistency Configure VD(s) Use Cursor Keys to Navigate Between Items And Press Enter To Select An Option ASUS RS100-E5-PI2 6-11