Asus S6F S6 Hardware User's Manual for English Edtion (E2422) - Page 41
Fast-Ethernet Connection - software support
View all Asus S6F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
4 Using the Notebook PC Fast-Ethernet Connection Connect a network cable, with RJ-45 connectors on each end, to the modem/network port on the Notebook PC and the other end to a hub or switch. For 100 BASE-TX speeds, your network cable must be category 5 or better (not category 3) with twisted-pair wiring. If you plan on running the interface at 100Mbps, it must be connected to a 100 BASE-TX hub (not a BASE-T4 hub). For 10Base-T, use category 3, 4, or 5 twisted-pair wiring. 10/100 Mbps Full-Duplex is supported on this Notebook PC but requires connection to a network switching hub with "duplex" enabled. The software default is to use the fastest setting so no user-intervention is required. Twisted-Pair Cable The cable used to connect the Ethernet card to a host (generally a Hub or Switch) is called a straight-through Twisted Pair Ethernet (TPE). The end connectors are called RJ-45 connectors, which are not compatible with RJ-11 telephone connectors. If connecting two computers together without a hub in between, a crossover LAN cable is required. Example of the Notebook PC connected to a Network Hub or Switch for use with the built-in Ethernet controller. Network Hub or Switch LAN connector is the larger of the two. Network cable with RJ-45 connectors WARNING! Only use analog telephone outlets. The built-in modem does not support the voltage used in digital phone systems. Do not connect the RJ-11 to digital phone systems found in many commercial buildings or else damage will occur! 41