Asus SABERTOOTH X58 Sabertooth X58 user's manual - Page 48
Marvell, Serial ATA 6.0 Gb/s connectors, pin SATA_6G_1, 7-pin SATA_6G_2 [gray] - marvell driver
View all Asus SABERTOOTH X58 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Chapter 2 2. Marvell® Serial ATA 6.0 Gb/s connectors (7-pin SATA_6G_1, 7-pin SATA_6G_2 [gray]) These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA 6.0 Gb/s hard disk drives. • These connectors are set to IDE Mode by default. When using hot-plug and NCQ, set the Marvell 9128 Controller item in the BIOS to [AHCI Mode]. Refer to section 3.6.3 Onboard Devices Configuration for details. • You must install Windows® XP Service Pack 2 or later versions before using Serial ATA hard disk drives. • Press + during POST to enter the Marvell RAID utility to create or delete a RAID configuration. • If you want to install a Windows operating system to a RAID configuration created using the Marvell SATA controller, you have to create a RAID driver disk using the motherboard support DVD and load the driver during OS installation. For 32/64bit Windows XP OS, load first the Marvell shared library driver, and then load Marvell 91xx SATA Controller Driver. For Windows Vista / Windows 7 OS, load only the Marvell 91xx SATA Controller Driver. 2-30 Chapter 2: Hardware information