Asus ZenScreen MB16ACM MB16AC Series User Guide - Page 24

Problem Possible Solution After connecting with the USB Type-C source device, the power LED lights continuously blinking or showing ASUS logo repeatly • Insufficient power supply from source USB Type-C devices. Please follow below steps: • Press the Blue Light Filter button , and then connect the USB Type-C cable. This operation will enable built-in safe mode. After displaying ASUS logo, please release the Blue Light Filter button. After ASUS Logo disappearing, there is "safe mode" message OSD showing up. Once "safe mode" message OSD disappears, please set background color to white image or nearly white image (*1). • Press MENU button, main menu OSD is showing. The upper left corner of the OSD will display small red-colored font "S", indicating it is now in safe mode. Enter brightness setup, press the up key to tune up brightness. During the process, please note down brightness value "Y" up until MB16AC/MB16ACR/ MB16ACM/MB16ACE re-start.(*2). For example, if brightness value shows "70" and MB16AC/MB16ACR/MB16ACM/MB16ACE restarts when adjusting to "71", "70" is the "Y" value to note down and is the highest brightness value for the connecting USB-C source device. • Press MENU button, main menu OSD is showing. The upper left corner still indicate "S" as safe mode. Adjust the OSD brightness value to "Y" • Close the OSD and press Low Blue Low Filter hot key for 5 seconds to turn off safe mode. • Complete. *1: White color background will consume higher power, so it's better to use white color background to test the power limit from source USB Type-C device. *2: If MB16AC/MB16ACR/MB16ACM/MB16ACE does not re-start when adjusting to value 100, that means source USB Type-C device has sufficient power supply. 3-12 Chapter 3: General Instruction