Audiovox CCDFR Installation Instructions - Page 9
Angle Flush Mount Installation
View all Audiovox CCDFR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Angle Flush Mount Installation: 1. Select a suitable mounting location in the rear center of vehicle. Check behind panel for wire routing access and confirm that the drill will not damage any existing components. Drill four 1/8" positioning holes and one 7/8" mounting hole at the mounting location according to the drawing of Size of Mounting Holes. 2. Screw the lock nut (# 3) and the flat washer 2 (# 7) with the non-threaded side to the camera neck in the showed direction. 3. Mount the slant washer 2 (# 9) to the interior mounting surface. 4. Place the camera neck through the pervious drilled hole with the lens exposed. Then place the slant washer 1 (# 8) to the exterior mounting surface. 5. Tighten the top cover (# 5) towards the camera body. 6. Hold the top cover (# 5) by hand and tighten the lock nut (#3) towards the topcover (# 5) with the camera cable downwards. 7. Route the camera cable thru an existing grommet into the vehicle. 8. Connect the camera cable to the extension cable and route towards the monitor. 8 128-6951 9 of 12