Audiovox DTT7810FM Operation Manual - Page 13

System Panel Controls DTT7810 Operation SETTING THE CLOCK: NOTE: All settings are preformed in standby mode. 1. Selecting 12 or 24 hour display mode: a.) Press the "clock mode" button once. The 12H/24H and AM/PM indicator will flash. b.) Press the "radio tune/clock set" (-) or (+) button to toggle between 12 or 24 hour modes. 2. Setting the time: a.) Press the "clock mode" button twice. The hours and minutes will flash. b.) Press the "radio tune/clock set"(-) button to set the hour. This will also set AM/PM. c.) Press the "radio tune/clock set"(+) button to set the minutes. 3. Selecting the alarm type: a.) Press the "clock mode" button three times. The alarm indicator will flash. b.) Press the "radio tune/clock set" (-) or (+) button to toggle between the three alarm options (Alarm/Radio and OFF). A musical note will appear to indicate the radio has been selected. A bell will appear to indicate the alarm tone has been selected. If the alarm OFF mode is selected there will be no indicator displayed 4. Setting the alarm time: a.) Press the "clock mode" button four times. The alarm indicator will be displayed and the hours and minutes will flash. b.) Press the "radio tune/clock set" (-) button to set the hour. This will also set AM/PM. c.) Press the "radio tune/clock set" (+) button to set the minutes. Note: During any of the setting procedures if no buttons are pressed for four (4) seconds the DTT7810FM will go back to standby mode. OPERATION SELECTION: Note: The DTT7810 default source is the DVD shuttle. When power is turned OFF the DTT7810FM will default to the DVD shuttle. SOURCE SELECTION: 1. DVD mode - When power is turned ON the DTT7810FM will be in DVD mode. When one of the DVD shuttles is installed it will power ON a moment after the DTT7810FM is turned ON. 2. TV mode - Press the "Source" button once. - The DTT7810FM will be in TV tuner mode. 3. AV mode - Press the "Source" button twice. - The DTT7810FM will be in AV mode. Any A/V source connected to the AV inputs on the rear of the unit will be displayed. 4. Radio mode - Press the "Source" button three times. - The DTT7810FM will be in Radio mode. The unit will be in the last band that was selected (FM1, FM2, or AM) 11