Audiovox DV1201 Owners Manual - Page 39

Trouble Shooting Guide SYMPTOM CAUSE (AND REMEDY) • The location and orientation of the antenna are incorrect. If you use an indoor antenna, change to an outdoor antenna. • The TV antenna wire is too close to the Unit. Separate the antenna wire of the TV set from the Unit. No sound or only a very low-level sound is heard. • Check that the speakers and equipment are connected securely. • Make sure that you've selected the corrected equipment on the system. • The system is in pause mode or in Slow-motion Play mode. Press the PLAY button to return to normal play mode. • Fast forward or fast reverse is performed. Press the PLAY button to return to normal play mode. • Check the speaker settings. • Make sure that AUDIO output and AV IN input connections correct. • Adjust the speakers volume. • The DTS DVD disc cannot be decoded to have speaker output. • This Unit is too hot, shut off half 30 minutes for cool down. • You can use the Pink Noise setting to test that the speaker output is present (Please see Customizing the Function Settings) Severe hum or noise is heard. • Check that the speakers and equipment are connected securely. • Check that the connecting cords are away from a transformer or motor, and at least 10 feet (3 meters) away from a TV set or fluorescent light. • Move your TV away from the audio equipment. • The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol. • Clean the disc. • Vibrations from the speakers are affecting the Unit. The remote does not function. • Remove any obstacles between the remote and the Unit. • Use the remote near the Unit. • Point the remote at the remote sensor on the Unit. • Replace all the batteries in the remote with new ones. The disc does not play. • There is no disc inside ("No Disc" appears on the TV screen). • Insert the disc correctly with the playback side facing down on the disc tray. • Clean the disc. • A non-NTSC or PAL disc has been inserted. The Unit and disc region number are incompatible. Press the ZOOM/TV MODE button on the remote to output the video signal. • Condensation may have formed inside the Unit due to a sudden change in temperature. Wait about an hour for it to clear and try again. The DVD door cannot • Reset the Unit, press the STANDBY/ON button to turn off the Unit, wait for a few open. seconds, then restart the Unit. E-36-38.pmd E - 38 38 4/26/2004, 10:35 AM