Audiovox FPE3707HR Operation Manual - Page 22

Memorizing the Channels When the TV powers on for the first time after purchase, the initial auto channel search is invoked. This unit can automatically find all channels available through antenna or cable inputs, and store them in memory. Note: Be sure to select the TV input (refer to section on previous page) before operation. Selecting the TV Source Before your TV can memorize the available channels, you must specify the type of signal source that is connected to the unit. (i.e., an antenna or cable system) 1 In full screen mode, press MENU to display the main menu. 2 Press 4or3 to display CHANNEL SETUP menu page, press 6 to enter. 3 Press 6or 5 to select TV Source item, press 3or4 to select AIR or CABLE.  Select AIR if using antenna.  Select CABLE if using cable. CHANNEL SETUP TV Source Current Channel Channel Label Channel Skip Favorite Channel Auto Search Input Select Signal Strength AIR 2-1 WGBHOFF OFF > > > > > > Auto Channel Search If TV Source is set to AIR: highlight Auto Search in the CHANNEL SETUP menu and then press 4or 3 to begin the auto channel search, the unit will automatically search for all available TV/DTV program. CHANNEL SETUP TV Source Current Channel Channel Label Channel Skip Favorite Channel Auto Search Input Select Signal Strength AIR 2-1 WGBHOFF OFF > > > > > > If TV Source is set to CABLE: highlight Auto Search in the CHANNEL SETUP menu and then press 4or 3, now a Channel Scan Source window opens up. Use 4or 3to select one of STD, HRC, IRC and then press OK to begin the auto channel search, the unit will automatically search for all available CATV/CADTV program. Channel Scan Source STD HRC IRC Note: l If you want to stop the auto-search, press MENU button. l Select one of Cable STD/HRC/IRC according to your local area's cable system, normally please select STD. Channel Skip After setting channels into memory, you can skip unnecessary channels so that only the channels you want to watch are selected with Channel up/down buttons. 1 Navigate to the CHANNEL SETUP menu. 2 Highlight Current Channel item, use 3or4 to select an unwanted channel. 3 Highlight Channel Skip item, use 3or4 to set ON. CHANNEL SETUP TV Source Current Channel Channel Label Channel Skip Favorite Channel Auto Search Input Select Signal Strength AIR 2-1 WGBHON OFF > > > > > > 4 If you want to skip other unwanted channels, repeat the above steps. 5 Press EXIT button to exit. Now when you use CH+/- buttons to cycle among the channels, the skipped channels can not be selected. 20