Audiovox LXA300 Operation Guide - Page 4
Wiring - amplifier
![]() |
View all Audiovox LXA300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
® Wiring Power and Outputs LXA300 30A 30A FUSE + 12V RMT GND L+ L- R- R+ POWER SPEAKER Power Terminal (BATT +12V) Connect directly to the vehicle battery+ terminal with 8 gauge wire (minimum). + 12V RMT GND Not Supplied 30 amp Fuse or Circuit Breaker Spade Connector Battery Terminal Adapter Install as close to the battery as possible To Battery+ Terminal 8 Gauge Wire Ground Terminal (GND) Connect to a good chassis ground. The ground connection should be to clean, unpainted metal to provide a good electrical connection. + 12V RMT GND Remote Terminal (RMT +12V) Connect the radio power antenna lead from the receiver to the amplifier REMOTE terminal. This turns the amplifier on whenever the receiver is turned on. If a power antenna lead is not available, connect this wire to the radio or accessory fuse. + 12V RMT GND Butt Connector (not supplied) Spade Connector To Receiver Power Antenna Lead 18 Gauge Wire Fuses FUSE Use only one 30 amp blade-type fuse. Ring Connector Sheet Metal Screw (supplied) Drill 1/8" hole in chassis sheet metal Spade Connector 8 Gauge Wire 4
![](/manual_guide/products/audiovox-lxa300-operation-guide-6d2a267/4.png)