Audiovox P-950 Owners Manual - Page 5

bl AM/FM BAND SELECTOR (BAND) stereo signal. If the stereo signal is too noisy for comfortable Each time this button is pressed, the radio band is changed. The indication AM1, AM2, FM1, FM2 or FM3 will appear on the display panel according to your selection. bm UP/DOWN TUNE/SEEK/TRACK ( / ) BUTTONS To manually select a radio station, momentarily press the Up Tuning ( ) button to advance the unit higher, or the Down Tuning ( ) button to tune lower within the selected band. Pressing either for longer than 0.5 second and then releasing will activate the Automatic Seek Tuning function. The radio will seek the next available station in the selected direction and stop at that frequency. The Seek function can be stopped by pressing the button again or activating any other tuning function. bn LOCAL/ILL BUTTON listening, press the FM Mono/Stereo Selector button to switch to mono reception (the ST indication will disappear from the display panel). To return to stereo reception mode, press the button again so that the ST indication appears in the display panel. bp PRE-SET SCAN (PS) /AUTO-STORE TUNING (AS) Press this button momentarily to scan the stations pre-set into the six memories of the current band in use. The unit will stop at each pre-set station for 5 seconds before continuing to the next pre-set station (the pre-set number on the display panel will flash during Pre-Set Scan operation). Press the button again momentarily to stop Pre-Set Scan operation and remain on the selected frequency. If no buttons are pressed during the scan, the unit will return to the original station before the scan started. Pressing and holding the button for longer than 2 seconds will This feature is used to select the strength of the signals at which activate the Auto-Store Tuning feature which will automatically scan the radio will stop during Automatic Seek Tuning. Pressing and and enter up to 6 stations into the pre-set memories on the band in holding the button will select the Local setting (LOC will appear on use. If you have already set the pre-set memories to your favorite the display panel) and only strong (local) stations will be received. stations, activating the Auto-Store Tuning feature will erase those Pressing and holding the button again will select the Distant setting stations and enter the new ones. This feature is most useful when (LOC will disappear from the display panel) and the radio will stop traveling in a new area where you are not familiar with the local at a wider range of signals, including weaker (more distant) stations. Each time the button is momentarily pressed and released, the VFD display panel back-lighting intensity will change from low-tomedium-to-high, and then back to low, thereby providing three different intensity settings. bo FM MONO/STEREO BUTTON (MONO) During FM radio operation, this button is used to select mono or stations. bq STATION PRE-SET MEMORIES To set any of the 6 pre-set memories in each band, use the following procedure: 1. Turn the radio on and select the desired band. bm 2. Select the first station to be pre-set using the Manual TUNE or Automatic SEEK Controls . stereo reception of the broadcast signal. Under normal reception conditions, the unit should be left in the stereo mode as indicated by the ST indication on the display panel when tuned to an FM -5- 3. Press the pre-set button to be set and continue to hold it in for approximately 2 seconds. The preset number, followed by CH (channel), will appear on the display panel