Audiovox XMC-10A Installation Guide - Page 9

VERTICAL MOUNTING SWIVEL CONFIGURATION ADJUSTMENT SCREW XMC10 CRADLE ASSEMBLY PLASTIC LINER AND ADHESIVE BACKING SWIVEL BRACKET SIDE (HORIZONTAL) MOUNTING CONFIGURATION 3. Using Other Manufacturer's Mounts The XMC10 Cradle can also be installed using other manufacturer's mounts; the mounting plate provisions on the rear and bottom of the cradle provideyou with two mounting options within the vehicle using various vehicle-specific aftermarket brackets. 4. Installing the Xpress XM® Receiver into the Cradle SCREW HOLES (2) FOR DIRECT HARD MOUNTING Install the Receiver as follows: a. After making sure the connectors and guide pin hole are properly lined up, gently lower the Xpress XM® Receiver into the cradle and press down on the Xpress XM® Receiver to mate the connectors together. The raised detent on the cradle will enter the notch on the rear of the Receiver, indicating the Xpress XM® is properly seated. b. The Xpress XM® Receiver should now be secured in the cradle -9- 128-7472 9 of 16