Avanti IMD250 Instruction Manual - Page 13
Attention
View all Avanti IMD250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
PROBLEMS WITH YOUR ICE MAKER? You can solve many common ice maker problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE Problem Possible Cause Suggested Solutions The compressor works The voltage is lower than Stop the ice maker and do not restart abnormally with a buzzing required until the voltage is normal. noise. Water shortage indicator There is not enough water Press the power button, fill with water, Light is ON. in the reservoir. press the power button again to restart. Indicator lights are OFF. 1. Blown home fuse/ no Replace fuse / turn power on. power/blown breaker There is no water or water level 1. Dirty water level probe Clean the water tank, especially the is low, but the lack of water 2. Broken probe circuit two stainless steel water level probes indicator is not on Call the service Lack of water indicator is ON, 1. Abnormal water resistant 1. Add a little salt inside the water but there is enough water inside value 2. Call the customer service dept. the water tank. 2. Broken probe circuit Conditions for ice making cycle Refrigerant leaks/ sealed Replace unit. are right but no ice is made. system is blocked. Both alert and ice full indicators The water tray does not are on. turn. Check for blocked ice cubes, restart the unit. ATTENTION ICE MAKER USAGE For best results and most efficient operation of your ice-maker, it is recommended that you consume the ice as it is made or store the cubes in a separate container. Ice cubes left in the ice-bin will begin to slowly melt and the water will re-deposit into the water tray. If you are not going to consume the ice cubes as they are made, do not fill the water tray to the full line while the ice-bin is full. When the red "ICE FULL" indicator is on, remove the cubes and store in a separate suitable container. If you plan to leave the unit running overnight, it is recommended that you remove any cubes left in the bin and store in a separate container. If at any time the "ICE FULL" and "ADD WATER" indicators are on and flashing at the same time, push the POWER button, remove all the ice from the drawer, check and fill water when needed, wait for 3 minutes and then push Power button to start the ice making again. This unit is not designed to store the ice cubes produced for long periods of time. 13