Avanti MCDW24WI Install Manual - Page 9
H= 35 7/8 - 37 3/4 910mm-960mm
![]() |
View all Avanti MCDW24WI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
ADJUSTING HEIGHT First Step: Before the dishwasher is placed in the cabinetry, the front feet are closed until the end and the dishwasher is placed in the cabinetry. Second Step: Adjust the forefoot level with a flat screwdriver to stabilize the dishwasher and raise it to the enclosure height. Third Step: Adjust the rear foot level by placing a Philips screwdriver into (c) point balance and raise the dishwasher to the enclosure height. - Make sure the dishwasher is plumb and notice dishwasher can be placed with a small clearance under the counter top. - For front feet; turning the feet in the direction of the black arrows with the flat screwdriver allows the dishwasher to move downwards. - For rear feet; Turning the Philips screwdriver in the direction of the black arrows will take the dishwasher feet down. (c):Rear foot level adjusting point If the height of the enclosure s 33 7/8 "to 35 7/8" (860mm-910mm) use short supports as shown in the figure. opt.(+50) H= 35 7/8" - 37 3/4" (910mm-960mm) If the height of the enclosure s above 35 7/8 "(910mm) use long supports as shown in the figure. 9
![](/manual_guide/products/avanti-dwf24v0w-install-manual-8e9e5e1/9.png)