Avanti Model Instruction Manual - Page 13

Problems With Your Beverage Cooler?

Get Avanti Model PDF manuals and user guides View all Avanti Model manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

PROBLEMS WITH YOUR BEVERAGE COOLER? You can solve many common Beverage Cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE PROBLEM Beverage Cooler does not operate. Beverage Cooler is not cold enough. Turns on and off frequently. The light does not work. Vibrations. The Beverage Cooler seems to make too much noise. The door will not close properly. Display flashes Error message "E0" Display flashes Error message "E1" Display flashes Error message "E2" Display flashes Error message "HH" Display flashes Error message "LL" POSSIBLE CAUSE Not plugged in. The appliance is turned off. The circuit breaker tripped or a blown fuse. Check the temperature control setting. The door is opened too often. The door is not closed completely. The door gasket does not seal properly. The room temperature is hotter than normal. A large amount of contents has been added to the Beverage Cooler. The door is opened too often. The door is not closed completely. The temperature control is not set correctly. The door gasket does not seal properly. Not plugged in. The circuit breaker tripped or a blown fuse. The light button is "OFF". Check to assure that the Beverage Cooler is level. The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your Beverage Cooler. Contraction and expansion of the inside walls may cause popping and crackling noises. The Beverage Cooler is not level. The door is misaligned. The Beverage Cooler is not level. The gasket is dirty. The shelves are out of position. Connection failure - there is a wire or component that is not connected correctly. Contact the Avanti Service Department - 1 - 800 - 220 - 5570 Temperature sensor failure. Contact the Avanti Service Department - 1 - 800 - 220 - 5570 Defrost sensor (Coil Sensor) failure. Contact the Avanti Service Department - 1 - 800 - 220 - 5570 Temperature of inner cabinet is over 99ºF / 37ºC Temperature of inner cabinet is under 32ºF / 0ºC 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
13
PROBLEMS WITH YOUR BEVERAGE COOLER?
You can solve many common Beverage Cooler problems easily, saving you the cost of a possible
service call. Try the suggestions below to see if you can solve the problem before calling the servicer.
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
Beverage Cooler does not operate.
Not plugged in.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
Beverage Cooler is not cold enough.
Check the temperature control setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
Turns on and off frequently.
The room temperature is hotter than normal.
A large amount of contents has been added to
the Beverage Cooler.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The light does not work.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The light button is “OFF”.
Vibrations.
Check to assure that the Beverage Cooler is
level.
The Beverage Cooler seems to make too much
noise.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
Beverage Cooler.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The Beverage Cooler is not level.
The door will not close properly.
The door is misaligned.
The Beverage Cooler is not level.
The gasket is dirty.
The shelves are out of position.
Display flashes Error message “E0”
Connection failure – there is a wire or component
that is not connected correctly.
Contact the Avanti Service Department –
1 – 800 – 220 – 5570
Display flashes Error message “E1”
Temperature sensor failure.
Contact the Avanti Service Department –
1 - 800 – 220 - 5570
Display flashes Error message “E2”
Defrost sensor (Coil Sensor) failure.
Contact the Avanti Service Department –
1 - 800 – 220 – 5570
Display flashes Error message “HH”
Display flashes Error message “LL”
Temperature of inner cabinet is over 99ºF / 37ºC
Temperature of inner cabinet is under 32ºF / 0ºC