Avanti RIM49U3S-IS Instruction Manual - Page 22

TROUBLESHOOTING Before Calling for Service If the unit appears to be malfunctioning, read through the OPERATION section of this manual first. If the problem persists, check the Troubleshooting Guide on the following pages. Some of the problems mentioned in the Guide can be solved easily without a service call. Problem The machine doesn't operate. The water doesn't feed in after the machine starts. Machine makes ice, but bin does not fill up with ice. Water is leaking out of the unit. Cubes are partially formed or are white on the bottom. Noise during operation Possible Cause The ice maker is unplugged. The fuse is blown. The ice maker power button is set at OFF. The ice storage bin is full of ice. The water supply tap is turned off. The water supply pipe is not properly connected. The condenser may be dirty. The air flow to the ice maker may be obstructed. The ambient temperature and water temperature are high, or unit is near some heat source. Some water falls to the floor when you open the door to remove ice from storage bin. Water supply connection is leaking. Drain pipe higher than drain outlet. Not enough water in the water trough. The feet are not leveled and locked. Certain sounds are normal. Probable Correction Plug the ice maker in. Replace fuse. If it happens again, call for service to check for a short circuit in the unit. Switch the ice maker power button to ON. Remove some ice cubes. Be sure the ice-full probe is free of ice. Turn on the water supply tap. Reconnect the water supply pipe. Clean the condenser. Check the installation. Check the installation. Normal condensation on the door or some water together with ice. Take care when you take out ice. Tighten fitting. See Connecting the water line. Lower drain pipe. Check if the water supply pressure is below 15 psig. Check water supply or filter may be restricted. Check for a water leak at the water trough. Level and lock the feet. See Leveling the Ice Maker. See Normal Sounds. 22