Avanti WIMD332PC-IS Instruction Manual - Page 11

Dispensing Cold Water. • Place the glass or cup directly below the dispenser and press gently against the button marked WATER. • Remove the amount of water as desired by continuously pressing against the button marked water. • Once the desired amount of water has been dispensed release the button and the machine will stop dispensing water. • Never remove the cup from below the dispensing outlet before the ice or water are finished dispensing. NOTE: Water will be cold after a few ice-making cycles. CARE AND MAINTENANCE Caution Failure to unplug the ice maker could result in electrical shock or personal injury.  Cleaning Your Ice Maker • To ensure the cleanliness of the ice cubes, water in the reservoir should be replaced every 24 hours. • Remove the drain plug to drain remaining water from the water reservoir when the ice maker will not be used for long period of time. Screw the drain plug back in place after the water has been drained. • Always change with fresh water before starting ice production at initial installation or after long shut-off periods. • Please clean your Ice maker regularly. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.  Space Requirements • During transportation, the incline angle of the cabinet should not be over 45° • Do not turn the Ice maker upside down. Problems could occur in the compressor and sealed system. • The Ice maker should be placed horizontally on a properly leveled surface. • To ensure proper ventilation for your Ice maker allow 6" of space at the top, the back and on each side. • Before using the Ice maker for the first time, please wait 2 hours after positioning it. • Clean the inner liner, ice-bin, water box, water cup frequently. IMPORTANT: Do not install the Ice maker near an oven, radiator, or other heat source.  Power Failure Most power failures are corrected within a few hours and should not affect the temperature of your ice maker if you minimize the number of times the ice-bin is opened. If the power is going to be OFF for a longer period of time, you need to take the proper steps to disconnect your appliance. 11