Behringer 110 VCO/VCF/VCA Quick Start Guide - Page 2

2 110 VCO/VCF/VCA Installation The necessary screws are included with the module for mounting in a Eurorack case. Connect the power cable before mounting. Depending on the rack case, there may be a series of fixed holes spaced 2 HP apart along the length of the case, or a track that allows individual threaded plates to slide along the length of the case. The free-moving threaded plates allow precise positioning of the module, but each plate should be positioned in the approximate relation to the mounting holes in your module before attaching the screws. Hold the module against the Eurorack rails so that each of the mounting holes are aligned with a threaded rail or threaded plate. Attach the screws part way to start, which will allow small adjustments to the positioning while you get them all aligned. After the final position has been established, tighten the screws down. Specifications Inputs Pulse width mod Type Impedance Maximum input level Signal input Type Impedance Max input level VCO mod input Type Impedance CV range VCF mod input Type Impedance CV range VCA mod input Type Impedance CV range 3.5 mm TS jack, DC coupled >70 kΩ, unbalanced 0 V to +10 V, 4% per volt 4 x 3.5 mm TS jacks, AC coupled >50 kΩ, unbalanced +17 dBu @ unity gain 2 x 3.5 mm TS jacks, summed >50 kΩ, unbalanced 0 V to +10 V, 1 V/oct 2 x 3.5 mm TS jacks, summed >50 kΩ, unbalanced 0 V to +10 V, 1 V/oct 2 x 3.5 mm TS jacks, summed >50 kΩ, unbalanced 0 V to +10 V, typically 1 V per 10 dB Outputs VCO output Type Impedance Max output level Frequency range with no external CV Frequency range using external CV VCA output Type High impedance Low impedance High max output level Low max output level High output noise Low output noise Controls Pulse width manual Waveform Range Pitch Cutoff frequency Resonance Sig in level Mod in level VCA initial gain Power Power supply Current draw Physical Dimensions Rack units Weight 3.5 mm TS jack, DC coupled 1 kΩ, unbalanced 10 V p-p