Behringer EUROPOWER PMH5000 Manual - Page 10
Wiring Examples
View all Behringer EUROPOWER PMH5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
EUROPOWER PMH1000/PMH3000/PMH5000 OUTPUT B +1 OUTPUT A +1 8 Ω -1 -1 4 Ω BRIDGE +1 +2 8 Ω 4 Ω 16 Ω 8 Ω Fig. 4.6: SPEAKON® pin assignment 5. WIRING EXAMPLES Fig. 5.2: Bridged mono operation This illustration shows the power mixer with a sub-woofer connected to OUTPUT B. For a bridged mono operation to OUTPUT B, the AMP MODE selector switch must be set to its lower position "BRIDGE". A separate stereo power amp (BEHRINGER EUROPOWER EP1500) connected to the preamp main outputs delivers the stereo main signal. Two active monitor speakers for on-stage operation are connected to the preamp monitor output. Fig. 5.1: Stereo operation For stereo operation the POWER AMP switch must be set to its upper position (MAIN or MAIN L/MAIN R). Outputs A and B provide the stereo main signal for passive speakers. The preamp monitor output is connected to two parallel active speakers, which are used as on-stage monitors. Use the footswitch to enable/disable the effects processor. 10 5. WIRING EXAMPLES