Behringer U-CONTROL UMA25S Manual - Page 20

20 U-CONTROL UMA25S User Manual SysEx Dump ALL: By turning the E11 rotary knob, the entire memory contents of the 16 presets is sent as SysEx dump via MIDI. During the dump, the display flashes "Run". You can cancel the process by turning the E11 rotary knob until "End" appears on the display. In order to receive a SysEx dump, no settings on your equipment have to be adjusted. ◊ CAUTION: If you send an "All SysEx Dump" to the U-CONTROL, the entire memory content is directly overwritten! There is no prompt for confirmation nor a memory safety function! SysEx Dump SINGLE: By turning the E12 rotary knob, the current preset is sent as SysEx dump. During the dump, the display flashes "Run". You can cancel the process by turning the E12 rotary knob until "End" appears on the display. In order to receive a SysEx dump, no settings on your equipment have to be adjusted. If you send a single preset to the UMA25S, the data are first stored in a temporary memory. In order to be stored permanently, save the data in a memory slot of your choice (see Chapter 5.1.2). MMC Frame Rate Select: The E13 rotary knob lets you adjust the frame rate: 24, 25, 30 (in each case "non-drop frame") or 30d ("drop frame"). This is an important setting for the MMC messages, which contain defined song positions (for example, Locate). Factory Reset (restoring default presets): Restoring default presets has already been described in Chapter 5.1.3. 1. In Global Mode, turn the E14 rotary knob until "FAC" (which stands for Factory Reset) appears on the display. 2. Press the ENTER key once to reset to the factory settings. Then, the UMA25S switches back to normal Play Mode. ◊ Caution! With Factory Reset, all configured data and user presets are irreversibly deleted! To avoid an accidental deletion, save your presets by sending a SysEx dump to your computer beforehand. • Press the EXIT push button to cancel the Factory Reset. 6. Specifications Audio Inputs MIC IN Connectors Input impedance Max. input level LINE IN Connector Input impedance Max. input level Audio Outputs LINE OUT Connector Output impedance PHONES Connector Output impedance Max. output level Digital Processing Converters Sampling rate USB Interface Connector Type 1/8" TRS connectors 5 kΩ +6 dBV RCA connector approx. 27 kΩ 0 dBV RCA connector approx. 400 Ω 1/8" TRS connector approx. 50 Ω -8 dBV, 2 x 1.3 mW @ 100 Ω 16-bit converters 32.0 kHz, 44.1 kHz, 48.0 kHz Type A USB 2.0; full-speed 12 Mbit/s USB MIDI class-compliant Global Send Channel: The UMA25S keyboard sends all keyboard information and control element data, which are assigned to the GLOBAL SEND CHANNEL over the global basis channel; the assignment takes place by selecting the MIDI channel "c00" for a control element in Edit Mode (see Chapter 5.4). When individual keys and control elements are assigned to other channels (1 - 16), the GLOBAL SEND CHANNEL has no effect on these elements. MIDI Interface Type Control Elements Controls Buttons Pedal inputs 5-pin DIN connector OUT 8 rotary knobs 1 pitch bend wheel 1 modulation wheel 1 volume slider 8 push buttons 1 sustain, 1/4" TS connector with automatic polarity detection 1 expression, 1/4" TS connector