Behringer U-PHONO UFO202 Manual - Page 11

11 U-PHONO UFO202 User Manual 3. Connect a monitoring device. You may plug speakers into the RCA outputs or connect a pair of headphones to the PHONES output. 4. Connect the attached USB cable to a free USB port on your computer. Line/Phono RCA Ins RCA Outputs Computer USB Headphone Out 5.2 Hooking up a tape player 1. Move the LINE/PHONO switch on the UFO202 to the left (LINE selected). 2. Connect a stereo RCA cable from the tape player outputs to the RCA inputs on the UFO202. 3. Connect a monitoring device. You may plug speakers into the RCA outputs or connect a pair of headphones to the PHONES output. 4. Connect the attached USB cable to a free USB port on your computer. 6. Recording Process • After hookups have been made and software installed, you are ready to record the audio. Make sure your audio recording program is set to record input from the USB port. For simple record, cut, and export of stereo audio, you may prefer to use Audacity • If recording from a tape player, make sure the player's volume is turned up all the way • Adjust the input sensitivity of the recording program to achieve optimal sound quality. Too much signal will cause the recording to distort; too little signal will sound faint and thin, so record a test clip to ensure quality sound. The recording program should have meters that display the levels as the audio streams • Set your recording program on your computer to RECORD, and begin playing the start of the tape or record immediately after • Let the audio play all the way through the first side. Once the music stops, press STOP on the recording program