Behringer UFX1204 Quick Start Guide - Page 16
Recording to USB drive in STAND-ALONE mode, Using the MIDI CONTROL Features - mixer
View all Behringer UFX1204 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
30 XENYX UFX1204 Recording to USB drive in STAND-ALONE mode (EN) Step 7: Recording to USB drive in STAND-ALONE mode Transport Control Feature Chart Show Remaining Time Show Sampling Rate Press TIME REMAIN short Push and hold TIME REMAIN button until the sample rate is displayed Select Sampling Rate 44.1 kHz Push and hold TIME REMAIN until the sample rate appears and then press while still holding TIME REMAIN Select Sampling Rate 48 kHz Toggle PLAYPAUSE Toggle Recording Mode (e.g. l001z) Playlist Mode (e.g. "P01") Toggle Single Playback (lPxxz) Continuous Playback (lcxxz) [only in Playlist mode] Push TIME REMAIN until the sample rate appears and then press while still holding TIME REMAIN Press PLAY (to start) > press PLAY (to pause) > press PLAY (to continue) > etc. Push TIME REMAIN + Push PLAY for two seconds for two seconds FAT-formatting the USB drive* Press together STOP + for two seconds Delete current song (in Recording Mode)* *press PLAY to confirm / any other button to abort Press together PLAY + for two seconds Error Codes: DrP FSE oFF SLO Dropout while recording. A summary of the total number of dropouts will be displayed after recording (e.g. d03). File system error. Incompatible file system on the drive. Drive must be formatted by the UFX. No external USB drive is recognized or connected. The connected USB drive has been specified as too slow. No recording will be possible. Although USB sticks and 2.5" USB-powered external drives could work, the use of powered hard drives for direct recording with the internal USB recorder is recommended. 31 Quick Start Guide Using the MIDI CONTROL Features (EN) Step 8: Using the MIDI CONTROL Features The TRANSPORT CONTROL section on the UFX1204 can operate as a MIDI controller in one of two modes: STANDARD MIDI MODE or MACKIE CONTROL MODE. The Mixer must be turned off. To select STANDARD MIDI MODE, hold , turn the power on, then release , when "Std" shows up in the display. To select MACKIE CONTROL MODE, hold , turn the power on, then release , when "MAC" shows up in the display. For STANDARD MIDI MODE, map the transport controls in your recording software to the TRANSPORT CONTROL buttons on the UFX1204. In MACKIE CONTROL MODE, set your recording software to follow the appropriate protocol.