Behringer X1622USB Manual - Page 15
Installation
View all Behringer X1622USB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
15 XENYX X2442USB/X2222USB/X1832USB/X1622USB User Manual SERIAL NUMBER Please note the important information on the serial number given in chapter 1.3.3. 6. Installation 6.1 Rack mounting The packaging of your mixing console contains two 19" rack mounts for installation on the side panels of the console. Before you can attach the rack mounts to the mixing console, you need to remove the screws holding the left and right side panels. Then, use these screws to fasten the two rack mounts, each specifically to one side. With the rack mounts installed, you can mount the mixing console in a commercially available 19" rack. Be sure to allow for proper air flow around the unit, and do not place the mixing console close to radiators or power amps, so as to avoid overheating. ◊ Only use the screws holding the mixing console side panels to fasten the 19" rack mounts. 6.2 Cable connections You will need a large number of cables for the various connections of the console. The illustrations below show the wiring of these cables. Be sure to use only highgrade cables. Balanced use with XLR connectors 21 3 input 1 = ground/shield 2 = hot (+ve) 3 = cold (-ve) 12 3 output For unbalanced use, pin 1 and pin 3 have to be bridged Fig. 6.2: XLR connections ◊ Caution! You must never use unbalanced XLR connectors (PIN 1 and 3 connected) at the MIC input jacks if you want to use the phantom power supply. Unbalanced ¼" TS connector strain relief clamp sleeve ¼" TS footswitch connector strain relief clamp sleeve tip tip sleeve (ground/shield) sleeve pole 1/ground tip pole 2 The footswitch connects both poles momentarily Fig. 6.1: Foot switch connector 6.2.1 Audio connections Please use commercial RCA cables to wire the 2-track inputs and outputs. You can, of course, also connect unbalanced devices to the balanced input/ outputs. Use either mono plugs, or use stereo plugs to link the ring and shaft (or pins 1 & 3 in the case of XLR connectors). Fig. 6.3: ¼" mono plug tip (signal) Balanced ¼" TRS connector strain relief clamp sleeve ring tip sleeve ground/shield ring cold (-ve) tip hot (+ve) For connection of balanced and unbalanced plugs, ring and sleeve have to be bridged at the stereo plug. Fig. 6.4: ¼" stereo plug