Beko CFG1691D User Manual - Page 11

3 Installation BPlease remember that the manufacturer shall not be held liable if the information given in the instruction manual is not observed. Points to be considered when re-transporting your refrigerator 1. Your refrigerator must be emptied and cleaned prior to any transportation. 2. Shelves, accessories, crisper and etc. in your refrigerator must be fastened securely by adhesive tape against any jolt before repackaging. 3. Packaging must be must be adequate and the rules of transportation printed on the package must be followed. Please do not forget... Every recycled material is an indispensable source for the nature and for our national resources. If you wish to contribute to recycling the packaging materials, you can get further information from the environmental bodies or local authorities. Before operating your refrigerator Before starting to use your refrigerator check the following: 1. Is the interior of the refrigerator dry and can the air circulate freely in the rear of it? 2. Please install the 2 plastic wedges as illustrated in the figure. Plastic wedges will provide the required distance between your refrigerator and the wall in order to allow the air circulation. (The illustrated figure is only an example and does not match exactly with your product.) 3. Clean the interior of the refrigerator as recommended in the "Maintenance and cleaning" section. 4. Plug the refrigerator into the wall outlet. When the fridge door is open, the fridge compartment interior light will come on. 5. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, even if the compressor is not running and this is quite normal. 6. Front edges of the refrigerator may feel warm. This is normal. These areas are designed to be warm to avoid condensation Electric connection Connect your product to a grounded socket which is being protected by a fuse with the appropriate capacity. Important: • The connection must be in compliance with national regulations. • The power cable plug must be easily accessible after installation. • The specified voltage must be equal to your mains voltage. • Extension cables and multiway plugs must not be used for connection. 11 EN